Bongeneering Project #2 - The Lung

I haven't listed any bongeneering projects of late, so here is one for all you do-it-yourselfers who are looking for a new project. Remember boys and girls using these devices to smoke marijuana is probably illegal and could get you arrested, the information is provided for entertainment purposes only.

The Lung:

This is another simple device to smoke up, it takes almost no time to construct, not nearly as smooth as the waterfall, but it is potent, and if you are a newbie be prepared to be knocked on your ass.

Materials:

• One small plastic pop bottle.
• Some tinfoil
• A small plastic Bag
• Duct Tape
  

Tools:

• A large philips screwdriver
• A Lighter
• A toothpick, small pin, needle
• Scissors
  

Directions:

1. Remove the lid of the pop bottle and remove the rubber liner from inside the lid.
2. Place the lid on a hard surface that will not burn or that you don't care if it burns
   
3. Heat up the screwdriver with the lighter.
4. Press the screwdriver down on the lid until you have a hole, the larger the hole the bigger the bowl you can make.
5. Leave the lid to cool.
6. Cut the bottom out of the pop bottle at the point where the bottle is completely round.
7. Cut any handles off the bag to make it completely round.
8. Tape the bag to the bottom of the bottle making an airtight seal so that the bag ads to the total volume available.
9. You may want to cut the bottom of the bag to size so that when the bag is pushed into the bottle it fits perfectly, use the duct tape to create a handle on the bag and seal the bag.
10. Push the bag up into the bottle so there is no air in the bottle.
11. Put the lid on the bottle.
12. Fill the bowl with your favorite smoking material.
13. Ask a fellow toker to hold the bottle.
14. Light the product, and pull the bag out from inside the bottle slowly so the bottle and bag fills with smoke.
15. Remove the lid and take a hit.
16. For best results try to take the full amount in one breath, but watch out, it is harsher then it first seems.