Bongeneering Project #1 - Waterfall

In this first of an on going series we will look at homemade devices for smoking up. Now remember check your local laws, I do not recommend using any of these for smoking any illegal substances, but if you want to use them for tobacco feel free.

The Waterfall:

This is a very simple device to smoke up, it takes almost no time to construct and is quite smooth.

Materials:

• One small plastic pop bottle.
• Some tinfoil

Tools:

• A large philips screwdriver
• A Lighter
• A toothpick, small pin, needle
  
• A water tap
  

Directions:

1. Remove the lid of the pop bottle and remove the rubber liner from inside the lid.
2. Place the lid on a hard surface that will not burn or that you don't care if it burns
   
3. Heat up the screwdriver with the lighter.
4. Press the screwdriver down on the lid until you have a hole, the larger the hole the bigger the bowl you can make.
5. Leave the lid to cool.
6. Heat up the screwdriver again.
7. Make hole on the bottle as close to the bottom as possible, make this hole small enough that you can cover it with your thumb.
8. If the lid has cooled line the outside of the lid with tinfoil allowing for a bowl to form in the hole created earlier.
9. Poke many small holes through the tinfoil with the toothpick or pin.
10. Fill the bowl with tobacco (or whatever you are smoking)
11. Take the bottle and the lid to the tap.
12. Covering the hole on the bottle with your thumb fill the bottle up to the neck with water.
13. Screw the cap back on.
14. Light the bowl and keep the flame going on the bowl as you remove your thumb and allow the water to drain out.
15. Remove the cap and suck out the smoke from the top of the bottle.